Klantbeoordelingen voor VEVOR Opklapbare Lastafel 30"x20" Werkbank 181kg Laadvermogen Hoogte Verstelbaar van 25" tot 32" Verstelbare Hoek 0°/30°/90° Werkbank Koolstofstalen Werkplaatstafel met Wielen

Tafel is prima voor mijn minimale TIG laswerk. Door de verstelmogelijkheden prima inzetbaar. Sommige vleugelmoeren zijn wat klein. Lekker compact als je deze opgeborgen hebt !.

Pretty impressed with this table for the price. The only major con is the poor means of securing the table tilt angle which relies on small wing nuts. However as you're a welder bend up some flat bar, weld on a nut and your fabricated levers will sort the problem.

I didn't find this hard to put together and I had no missing components, however there was a quality control issue. One of the legs was missing a drilled hole. Not an issue. I used the other as a template, marked and drilled it. But it dies speak to some of the problems others have had Once together it's a sturdy little industrial table People have clamped chop saws to them etc Mine is for holding components when welding outside If note currently 17 quid cheaper on vevors own website

Arrived well packed. All nuts and bolts were in the pack , but I needed a few washers. Of note , one of the legs didn't have the top hole drilled. No big issue Matched with the other and drilled Went together quickly and easily. It's sturdy and great quality. If you are happy to deal with the odd minor quality control issue , it's super value

Good quality product, but I found a couple of issues with the build instructions (e.g. the semicircular plates needed to be on the opposite side to the illustrations). Also, design wise I think they missed a couple of tricks: 1 - The nuts on the bolts holding the legs would be better with 'lock nuts' to allow better adjustment of the 'freeness', and to avoid them coming off if set too slack (I've done this, but had to also get longer bolts so the lock nuts 'engage') 2 - The table top clamping wing nuts are on opposite sides when build is complete (and the nicely painted sides are both on the outsides). This means the table top is clamped 'askew' (not by much, but avoidable), and that getting to the wing nut 'away from you' is 'fiddly'. My solution was to turn one side around, so I now have one fixing plate outside, and the other inside, and puts both wing nuts on the same side as the 'tool bar'... much easier to clamp now...

Great purchase In use all the time i purchased a 5mm piece of plywood for the top so to use as a tool bench fitted 6 high power magnets to one side dia12mm to stop the board from moving when tilted.

Awesome table, especially for the price. Folds up flat and had a carry handle. The legs do take some sorting and the plastic it comes in is a nightmare to get off on some of the red parts. But that’s a minor grips.

well made and very portable bit like ikea flatpack only with all the bits easy to use and pack away

Vlugge en perfecte levering Lastafel is goed verpakt en stevige structuur . Prijs kwaliteit is OK Een tevreden klant.

Erg gemakkelijk voor kleine ruimtes. Ik gebruik hem niet alleen om te lassen, maar ook als buiten tafel voor mijn afkort machine. Na gebruik, zet je hem zo weer aan de kant.