Klantbeoordelingen voor 6 '' Accu Lock Bankschroef Precisie Frezen Boormachine Bankklem W/Swivel Base

graag deze bestelling verwijderen, is afgehandeld. Dank u wel...................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

Very good value. Strong and well made. More than accurate enough for my hobby and repair shop. The only reason I did not give it Five stars all round was the very quaint English the manual is written in. Still, if you can't drive a vice without a manual you are probably not safe to be in a workshop anyway.

I bought one of these vices and was sos pleased that I purchased another one. I use them in tandem to hold large item on my milling machine. The moveable jaw can be reversed onto the back of the moveable jaw to hold large material. I find the ability to hold large plate material great for doing co-ordinate drilling and has proved to be extremely accurate.

A sturdy little vise. Excellent value for money.

A lot of vice for the price and a good heavy casting, well ground surface finish on the sliding surfaces and jaws. I just had to tidy up the edges of the base with a file as they were still sharp from grinding. The base will eventually be scraped in but for now it’s good enough. I think the maximum deviation over all with the vice fully open from fixed jaw to moving was with in 0.06mm I have provided photos showing DTI deviation but can only post five

Good value good quality. You need to adjust the Jaws to true parallel. Easy to do slacken Allen bolts and set to parallel with milling table

Good quality, easy to use. Fixing bolts were too big for my mini mill but I had some already I could use.

Got this after struggle with a smaller vise. These are modelled after the famous design of the American Kurt vise, but at a tiny fraction of the price. So wasn't expecting it to be as good as it turned out to be. Was well packed, came with a fixing kit, and was no trouble to setup. After fly cutting a part both sides on parallels the thickness was almost same on all corners (just over 0.01mm). Extremely good clamping force.

Very Pleased, just right for my mini mill **************************************************************************************************************************

Arrived very quickly, well packed. Very strongly built considering low price. Used for a week of continuous milling and never slipped once. Overkill for my Chester 626 mill I hadn't realised how big it was! Delighted with it except for the handle which was a little oversize and was marking the hexagon shaft. However the remedy was to substitute handle for a spanner. It still rates 11 out of 10 for me.