Klantbeoordelingen voor VEVOR Omvormer 3HP 2.2KW Variabele Frequentieaandrijving Vfd Avr Cnc Low-Output perfecte motor

Easy to configure, good instructions. Would be nice if it had an extension lead for the detachable lcd display. Overall, though well designed and packaged. Thanks!

Easy to use and seems to work fine. Fan is noisy but at least airflow is adequate. One thing to be aware of is the external button controls don't function the same as the built in panel for stop/start and rev. The external button must be latched to keep the motor running. I used a 3 way rotary switch in the end. No problems encountered with radio noise or interference, and the controller has good control of the motor start and stop speed. Even though it doesn't have braking, the motor spins down fast enough on my lathe. Not enough mileage to comment on reliability, but it been put through its paces with no signs of distress. Shame these units are discontinued, as I have a couple of other machines that could benefit from one.

Found it easy to use and connect up. I find it to be value for money.

a great product essay to set up out of the box wired up and running am really happy with with it the good thing as i can get intouch if there was ever a problem

Excellent quality unit , does all that is required of it. Only thing is that for a relatively inexperienced engineer set-up proved to be a little complex. Used to enable the use of a 3 phase Pillar drill where only sigle phase available. However achieved and now understand the manual much better. Will buy again for 3 other machines in due course

Does what it's supposed to at a great price. Time will tell on reliability but its holding up so far

Hoop verschillende dingen gehoord over deze site maar geen enkel probleem gehad met bestelling en levering. Prima kwaliteit voor een onverslaanbare prijs. Grootste nadeel is het ontbreken van een draaiknop om snel toeren te regelen maar dit was duidelijk op foto's voor de aanschaf dus niet ten nadele van vevor.

Arrived safely and worked very well.Has all the various functions that I need when I used it to run and regulate my 72 x 2 Belt Grinder

Bought this to try it, It was a low price, I have a Fobco Star drill with A three Phase motor, and I wanted to power it with 240v power. I rewired the motor To delta 240V , I had to change the setting from 400HZ to 50HZ and the motor starts and runs perfect , It is best to read the whole manual as there are a lot of setting that you can change. I bought the 1.5KW unit and it powered an old 0.33BHP / 0.25KW motor with no problems